Honda CBR 1000RR Forums banner

Quick question regarding installation of motodynamic integrated tail light..

968 views 5 replies 4 participants last post by  trojanliu 
#1 ·
Hello...

I am going to install a motodynamic integrated tail light on my 2014 cbr1000rr..

My quick question is...will I have to remove the tail fairings to properly install?
It should be a problem, but I was looking thru a service manual that a member here was nice enough to kick down, and saw that the fairings are clipped on?

Maybe I am reading the manual wrong...if anybody could shed light it would be greatly appreciated..thanks
 
#2 ·
It's been a while since I did mine but yes I think I had to remove tail section to access bolts for tail light. If you remove pillion seat there is 4 Allen key bolts. The tail then unclips from underneath. You have to stretch the plastic a bit to get it off. It's a bit daunting the first time, if you have to use too much force you have probably missed something.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top