Found this resting on my radiator...

http://img391.imageshack.us/img391/9019/picture0187po.jpg (http://imageshack.us) Basically when I did the flapper mod a looong time ago, I most likely did not seat the diaphragm in good enough, hence the reason it came loose. Bike has been running fine, who knows how long it's been like this for. Can I throw this piece of crap away? Do I need to to anything to my bike? thanks

Keep it as a souvenir on "how to not do the flapper mod"...

http://img391.imageshack.us/img391/9019/picture0187po.jpg (http://imageshack.us) Basically when I did the flapper mod a looong time ago, I most likely did not seat the diaphragm in good enough, hence the reason it came loose. Bike has been running fine, who knows how long it's been like this for. Can I throw this piece of crap away? Do I need to to anything to my bike? thanks Haven't done the full flapper and I am no mechanic wiz, but that thing sure looks important....HAHAHA

that thing just covers up the hole in the airbox. i've left mine attached to the airbox just for that reason. Some people have applied duct tape or epoxied a piece of plastic to cover the hole.

I bet you could make a bong out of it.

Once you install Mark's intake, you can throw that in the garbage :) Like said above, you've got a hole in the bottom of your airduct now... it's on the outside of the filters, so no biggy.

pierce your navel with it, i hear everyone's doing it

hah...okay so it's going to be used as a paperweight, fine just wanted to make sure it's not harming anything, which i doubt it is. and just a fyi: your $$ broke if your trying to smoke out of that thing

go with an HRC intake!

go with an HRC intake! link?

link? go to Mrgrn's section on the forum (below next to the other site sponsors). he sells them.