Honda CBR 1000RR Forums banner
Status
Not open for further replies.

"Big Swede Mod" on my 2008

4K views 16 replies 11 participants last post by  jKreu 
#1 ·
Finally finished it up. Purchased the fiberglass piece from darkangel and purchased an led strip with turn signals from amazon and modified it to fit the tail light housing.
 

Attachments

See less See more
2
#15 ·
Here is the LED Strip i used. This was not a direct fit since the wires comes out on the side and not the back so i snapped the circuit boards towards that end, removed some of the soldermask and was able to jumper the pads with some wire and solder to make this work. I work at a circuit boards manufacturing company so i do have a little background on what i needed to do after i snapped it


http://www.amazon.com/Integrated-5050led-Signal-Motorcycle-License/dp/B016Q1HAAY
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top