you dont need pics.......i ran into the same issue when installing my slipon.......all i did was use some force from my man hands to reshape the metal.....it's very easy......thank me when you are done
06/07 Pic request, help please.
Hello,
I am re-assembling my 07 after getting a few things powder coated(rear sets, passenger pegs/exhaust heat-shield) and was wondering if someone would be able to post a few detailed pics of the stock exhaust heat shield on the RH side where it goes behind the rear master cylinder and RH rear set & lower fairing area. While re-installing mine the heat-shield seems to be closer to the edge of the lower fairing than I remember when the bolt that goes thru the RH rearset to the heat-shield is tightened.
Thanks in advance!
-John
I am re-assembling my 07 after getting a few things powder coated(rear sets, passenger pegs/exhaust heat-shield) and was wondering if someone would be able to post a few detailed pics of the stock exhaust heat shield on the RH side where it goes behind the rear master cylinder and RH rear set & lower fairing area. While re-installing mine the heat-shield seems to be closer to the edge of the lower fairing than I remember when the bolt that goes thru the RH rearset to the heat-shield is tightened.
Thanks in advance!
-John
1 - 2 of 2 Posts
1 - 2 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda CBR 1000RR Forums
A forum community dedicated to Honda CBR 1000RR motorcycle owners and enthusiasts. Come join the discussion about troubleshooting, performance, modifications, classifieds, maintenance, and more!
Full Forum Listing
Explore Our Forums
