My 08' 1000rr stalled 6 times this weekend when I was coming to a stop after pulling the clutch in. I have been trying to watch the tach while coming to stop to pinpoint when it's happening but it never seems to die while I'm watching. I normally rev match as I come down through the gears so it only has been stalling once I get to first and am ready to come to a stop. I have tried pulling the clutch in at speed/high RPM and it seemed fine and will settle down to idle. I did notice a few times after pulling the clutch in that the engine would drop below idle speed and the bike would struggle a little and then come back up to idle. The bike idles fine and I have no issues there. I have recently installed a PC V and IRC so I'm wondering if they could be causing the issue. I never had this problem before I installed them. The first few hundred miles after the install the bike was fine though. Now I have had it happen about 6 times in 2 days. I am going to check the side stand interlock switch. I already checked for loose connections under the tank and at the battery. Any ideas?
Griff
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
