[taRR]

does this rivet look all right?

 

[Pipeline714]

Looks fine! Just make sure that in pics 1 & 2, you don't see any small fractures inside the rivit where you over-compressed it with the tool. Otherwise, you're good to go.

On second look, I zoomed in on pic one and it looks fine. Looks like you "almost" compressed it too much. But I didn't see any fractures.

Peace!

 

[taRR]

thanks, i think there is grease and stuff in the pic looks like little cracks

 

[JTSX1]

My rivets didn't come out perfectly, in fact, I bent the tool trying to perfect them and they have held up for a couple of track days and 2k road miles.

 

[taRR]

My rivets didn't come out perfectly, in fact, I bent the tool trying to perfect them and they have held up for a couple of track days and 2k road miles.

do they look worse than mine or the same?

 

[rebillet]

Looks good. If you have a caliper measure them before compressing them and after. THere are specs you can use from the manufacturer to make sure you press them enough but not too much.

 

[Slider]

Dude that link is upside down you can see it in the first picture.

 

[Strand]

Haha yeah but that doesn't matter. ^^^

 

[Slider]

Haha yeah but that doesn't matter. ^^^

I understand that jackass. You ruined it.

 

[Strand]

LMAO


Shit - I should have figured. But I never know with you.

 

[mugen91504]

Dude that link is upside down you can see it in the first picture.

Oh well,now he has an excuse to break the rivets and try again

 

[JTSX1]

do they look worse than mine or the same?

About the same except yours might be slightly flatter looking. I wouldn't worry too much.