Honda CBR 1000RR Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
902 Posts
Discussion Starter · #1 ·
I'm sorry if this is a repost but I've searched and couldn't find the answer I was looking for.

My question is in regards to the Hydraulic Clutch. Is there any way I can adjust the friction point so it grabs near the top of the clutch (near full release) ?
The clutch grabs about half way through releasing it and it's annoying in stop and go traffic...

On any of my old bikes with a cable clutch, I could simple spin the silver dial out on the end of the clutch lever and that would usually do the trick.

:popcorn2:
 

·
Registered
Joined
·
1,499 Posts
engagement point

buy a adjustable radial brembo master cylinder, you can change the feel and engagement point in the lever travel
 

·
Registered
Joined
·
575 Posts
Mine engages near the "top" of the relase point. But I think my clutch is just wearing out lol.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top