[Pretorius]

Hi all.
recently replaced starter motor on my 2009 ABS model.
starter works fine but now that everything is back together I’m getting a fault code, 2 flashes.
bike starts fine but idle is rough. Then revs pick up a bit and sounds normal then get the engine fault code comes.
Poor sensor connection somewhere or vacuum connection issue somewhere?

 

[DannoXYZ]

Hi all.
recently replaced starter motor on my 2009 ABS model.
starter works fine but now that everything is back together I’m getting a fault code, 2 flashes.
bike starts fine but idle is rough. Then revs pick up a bit and sounds normal then get the engine fault code comes.
Poor sensor connection somewhere or vacuum connection issue somewhere?

That's clue..

MAP-sensor vacuum-hose disconnected or pinched. or
MAP-sensor electrical connector loose or disconnected. or
MAP-sensor circuit wires damaged or connector terminals corroded.

Test circuit according to manual: 5v supply voltage, sensor ground, sensor-output

 

[Pretorius]

That's clue..

MAP-sensor vacuum-hose disconnected or pinched. or
MAP-sensor electrical connector loose or disconnected. or
MAP-sensor circuit wires damaged or connector terminals corroded.

Test circuit according to manual: 5v supply voltage, sensor ground, sensor-output

 

[Pretorius]

You biscuit! Vacuum hose was disconnected! Thank you 👊

 

[peterj59]

That's clue..

MAP-sensor vacuum-hose disconnected or pinched. or
MAP-sensor electrical connector loose or disconnected. or
MAP-sensor circuit wires damaged or connector terminals corroded.

Test circuit according to manual: 5v supply voltage, sensor ground, sensor-output

great job

 

[DannoXYZ]

Thank you! 👋