Honda CBR 1000RR Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
92 Posts
Discussion Starter #1 (Edited)
I am going to be parting out my 2006 1000RR. Before I get to parting out the whole thing I want to sell the motor. I freshened the motor last winter and only have about 100 miles on it since the build.

Here is what was all done to the motor,

Head

Head was thoroughly cleaned of all carbon build up
All exhaust and intake springs checked and within spec
Intake and exhaust valves checked and cleaned
Valves lapped

Motor

New CK186 Wiseco piston, ring, pin set 13.2:1
Cylinders honed to Wiseco specs
Rods weight matched to within 1/2g
All bearing clearances checked and fitted
All new Honda gaskets and seals
Stock Honda head gasket
New rod and main bolts

Transmission

Inspected all gears and shift dogs
Nothing replaced

This motor includes an STM slipper clutch. It also has a Woodcraft stator cover and clutch cover guard.

The motor was run on the dyno on 11/15/2020 and made 164.77 RWHP on premium pump. Motor runs great and pulls like crazy. Perfect for your track or street bike.

Qye-32IzTjKYLF2IBzLmxQ.jpg


WI6yH4CzQtOQJDAzRI5iMQ.jpg

QuZevmeGT5CJSESgLU-6gA.jpg

fSxwG6jvRHWMadNvGHzqoA.jpg

XGIX8WNhTcOMPX-eGGEwKg.jpg

WI6yH4CzQtOQJDAzRI5iMQ.jpg



$4000

I prefer local pickup but will ship if buyer gives me time to crate it and pays all shipping cost


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
8 Posts
I am going to be parting out my 2006 1000RR. Before I get to parting out the whole thing I want to sell the motor. I freshened the motor last winter and only have about 100 miles on it since the build.

Here is what was all done to the motor,

Head

Head was thoroughly cleaned of all carbon build up
All exhaust and intake springs checked and within spec
Intake and exhaust valves checked and cleaned
Valves lapped

Motor

New CK186 Wiseco piston, ring, pin set 13.2:1
Cylinders honed to Wiseco specs
Rods weight matched to within 1/2g
All bearing clearances checked and fitted
All new Honda gaskets and seals
Stock Honda head gasket
New rod and main bolts

Transmission

Inspected all gears and shift dogs
Nothing replaced

This motor includes an STM slipper clutch. It also has a Woodcraft stator cover and clutch cover guard.

The motor was run on the dyno on 11/15/2020 and made 164.77 RWHP on premium pump. Motor runs great and pulls like crazy. Perfect for your track or street bike.

View attachment 261120

View attachment 261121
View attachment 261122
View attachment 261123
View attachment 261124
View attachment 261125


$4000

I prefer local pickup but will ship if buyer gives me time to crate it and pays all shipping cost


Sent from my iPhone using Tapatalk
Fortunately my engine is fine, but I am looking for a front wheel and maybe a tank if you'll be selling either of those after your motor sells?
 

·
Registered
Joined
·
92 Posts
Discussion Starter #3
I have a 2 tanks and 2 sets of wheels


Sent from my iPhone using Tapatalk
 
1 - 5 of 5 Posts
Top