Honda CBR 1000RR Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter · #1 ·
I’m doing a tranny swap on my 06 rn and when I pulled the bearing/tranny assembly out I heard something fall into the oil pan. I dropped the pan and found the oil orifice and surprisingly this mystery washer lodged under the pickup. I’ve been searching all day and cannot find where the washer goes. I’m thinking it may have fell when I was taking the case cover off or something...it’s got a small protrusion on the inner diameter. I have half a mind to start assembling the clutch to see if I’m missing something along the way but I don’t wanna get too far and have to undo more work....throw some ideas at me 👍
263465
 

·
Registered
Joined
·
37 Posts
Discussion Starter · #6 ·
I’m actually updating this to say I solved it. The washer here is the last washer on the output shaft between the case and last gear. Couple guys told me they had this same thing happen when pulling a cassette style transmission
 
1 - 6 of 6 Posts
Top