Morning All,
Thought I'd tag my current track/race bike build from across the pond. Previous bike was a Triumph Daytona 675 2013 model used for Club 600 in a few local championships (Cracking bike). decided to upgrade to a 1000 so came across a 2017 UK base model CBR1000rr, had been written off by the previous owner on the road.
So far the bikes had:
Suspension - K-tech DDS front and rear fitted by Steve Whitear at HEL Performance. Ten-Kate steering damper brackets and K-tech damper (Toby).
Brakes - HEL calipers (Brembo Z04 pads, Motul RBF 660) and Master cylinder with dry break connections. Standard rear caliper with captive bracket - soon to have HEL thumb brake and HEL rear caliper.
Chassis - PP Tuning clip ons, Diamond racing rearsets, Evo-tech sliders, Spider captive wheel spacer, Ti fuel tank, UK race support clutch lever, alloy front and rear sub-frames, 520 racing chain.
Electronics - Ten-Kate loom, ECU and IMU relocated, BSB LHS switch gear, JMT Lithium battery. Yet to fit - Jet Prime RHS switch gear and HRC QA throttle, Honda blipper on route.
Bodywork - Hi-fibre tank and seat unit, Moto carbons carbon fairing and airtubes (Ex-Jackson Racing), pro-fibre carbon frame protectors, GB engine protection.
Performance - Full akra system, carbon bell mouths and MWR filter - 190Bhp & 85lb of torque, set up by Ben at REA Racing, silicone water hoses.
Only ridden her once at Andalucia and inital impressions are good, QS/Blipper didn't work due to switch gear issue (Hopefully resolved). But she's light, holds a tight line and good on the brakes - also matched bigger horse power bikes on the straight.
To Follow: Light weight wheels, track time and tyres!
Some on track vids to follow once the world turns the right way up again. Stay safe!
All the best Pablo
