Honda CBR 1000RR Forums banner

Where can I get Tony's short Arata?

945 Views 8 Replies 5 Participants Last post by  mrgrn
Anyone know where to find that short Arata system on Tony's 1000RR? Did he modify it?
1 - 9 of 9 Posts
im pretty sure he modified it. althought ive seen some shorty systems made just not for this bike. but shoot him a PM and he'll let u know for sure...
I did PM him. No reply yet.
give it a little bit of time tony gets on here a lot. im sure he'll let you know as soon as he signs in...
i can get you one like that in carbon, check my sig

300mm long and a 86mm round

$275
Tony is currently in transit. Most likely, he won't be on the board for a week or so.

Good luck.
Wasup! Mine is a ladybird muffler, but check out MRGRN's too. Both are very nice.
MRGRN

Nice! Is that 868 grams as in 1.9lbs?? Also... your profile said Bear Mt., NJ. I am NY very close to North Jersey border. Map Quest didnt recognize Bear Mt. Can i have your zip and do you mind if I come down?

Thanks, Eric
MRGRN

Nice! Is that 868 grams as in 1.9lbs?? Also... your profile said Bear Mt., NJ. I am NY very close to North Jersey border. Map Quest didnt recognize Bear Mt. Can i have your zip and do you mind if I come down?

Thanks, Eric
sure, PM me.

i don't have any here and they are special order cans built to spec.

tell me the size inlet i need and length of can and where you need the spings attached and we can go from there Eric

Mark
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top