Just leave them out. Wont hurt anything.
Yosh to stock.
So I need to put my stock pipe back on my 07 RR.
Sounds easy, except I pulled the cables out of the servo motor or whatever its called. Does anyone have a PDF or know where I can find the shop manual page telling me which cable goes where?
Sounds easy, except I pulled the cables out of the servo motor or whatever its called. Does anyone have a PDF or know where I can find the shop manual page telling me which cable goes where?
1 - 8 of 8 Posts
But what about the exhaust valve?Just leave them out. Wont hurt anything.
The valve will stay in the open position and will not hurt anything.
Basically maybe a little louder in the lower rpm but should be fine.But what about the exhaust valve?
I thought that valve was there to add low end torque?Basically maybe a little louder in the lower rpm but should be fine.
No, that's bs.I thought that valve was there to add low end torque?
It's there for emissions and noise.
Leave the cables off, the default position for the valve is open.
Ok cool thanks for the advice guys!No, that's bs.
It's there for emissions and noise.
Leave the cables off, the default position for the valve is open.
1 - 8 of 8 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda CBR 1000RR Forums
A forum community dedicated to Honda CBR 1000RR motorcycle owners and enthusiasts. Come join the discussion about troubleshooting, performance, modifications, classifieds, maintenance, and more!
Full Forum Listing
Explore Our Forums
